About the role
In Depth knowledge of DFMEA, PFMEA, CP and PFD
Method support (Sys. - FMEA, D-FMEA, HW-FMEA, P-FMEA IQ-RM / IQS Moderation.)
- Carry out the FMEA based risk analysis and ensure the release of FMEA by closing all the risk points.
- Preparing and Monitoring of Control Plan Prototype, pre-launch and production
- Hand on experience with Measuring instruments, CMM, VMM, rapid I, Vernier caliper etc.
- Child part Inspection and ISIR release for new development projects.
- Inprocess inspection, setup verification and support for process maturity during development.
- Attend the molding trial in-house and at supplier end to ensure the required improvements.
- Support for review of drawings for specifications & special characteristics
- Preparation of PPAP documents and customer approval.
- In house process Audits to make sure, defined spec. has been followed during assy.
- Must have hands on Experience on Problem Solving Technique – G8D, CAPA & QC Tools
- Must have experience of PPAP and APQP Documentation.
- Conducts SPC and MSA study
- Hands-on experience with Gauges concept review and finalization as per customer requirements.
- Verification of assy. fixtures, receiving gauges & final assy. gauges.
- Monitor the quality objectives achievement through a risk assessment follow up based on FMEA, key characteristics, capabilities, tolerance stack up, PPM etc.
- Attend project review meetings internal and along with customer.
- Handling customer PPAP, internal and compliance audits.
- Must have the Knowledge of IATF and Auditing Skill
- Experience in handling the Quality work products in line to IATF16949 and ISO26262 requirements.