About the role
Mechanical Technician - L&T Electrolysers R&D Lab
Department
Research & Development
Location
Hazira
Qualification
ITI - Fitter / Mechanical / Maintenance or Diploma in Mechanical Engineering
Experience
1-2 years in mechanical fitting, assembly, maintenance, piping/tubing, fabrication, pressure testing or industrial equipment installation
Job PurposeProvide hands-on mechanical support for the assembly, installation, testing, operation, maintenance and troubleshooting of electrolyser stacks and laboratory test systems, with strong focus on safe execution, equipment reliability and rapid R&D modifications.
Key Responsibilities- Assemble and dismantle electrolyser stacks including all the components.
- Perform controlled bolt/tie-rod tightening using specified torque procedures and support stack alignment and dimensional inspection.
- Install SS piping and instrumentation tubing as per P&IDs, layouts and engineering instructions; execute tube cutting, deburring, bending and compression-fitting installation.
- Installation, replacement and maintenance of pumps, valves, pressure regulators, heat exchangers, tanks/vessels, compressors, cooling-water systems and electrolyser test stations.
- Support hydrostatic, pneumatic and approved leak-testing activities; prepare test connections and check fittings, flanges and valves for leakage.
- Troubleshoot leakage, vibration, misalignment, loose connections, seal/gasket failure and other mechanical abnormalities.
- Carry out basic workshop activities such as fitting, drilling, tapping, grinding, cutting and assembly; support fabrication/modification of stands, frames, brackets, supports, enclosures and fixtures.
- Read basic mechanical drawings, assembly drawings, P&IDs and equipment/piping layouts; maintain maintenance, inspection and testing records and proper tool/equipment traceability.
- Follow approved SOPs, JSA/JHA, Permit-to-Work (PTW) and Lockout/Tagout (LOTO) requirements.
- Follow safe practices for hydrogen, oxygen, nitrogen, compressed gases, pressurized water and alkaline electrolyte, where applicable.
- Confirm isolation, depressurization and safe condition before opening or maintaining piping, valves, stacks or test equipment.
- Use required PPE, maintain good housekeeping and immediately report leaks, unsafe conditions, damaged equipment or abnormal operation.
Mechanical fitting & assembly | SS piping/tubing | Tube bending & compression fittings | Flange/gasket assembly | Torque tightening | Valve installation & maintenance | Pumps & rotating-equipment basics | Pressure/leak testing | Basic fabrication | Vernier/micrometer | Hand & power tools | Mechanical drawings & P&IDs | Preventive maintenance & troubleshooting
Preferred ExposureElectrolyser or hydrogen test systems (added advantage, not mandatory); process/utility piping; pressurized gas or liquid systems; SS316/SS316L tubing; Swagelok-type compression fittings; hydraulic torque tools; pressure regulators and safety valves; prototype/R&D equipment assembly.