About the role
Electrical & Instrumentation Technician
Department
Research & Development
Location
Hazira
Qualification
ITI/Diploma in Electrical / Instrumentation or E&I Engineering
Experience
1-2 years of experience in industrial electrical and instrumentation maintenance.
Job PurposeProvide hands-on Electrical & Instrumentation support operation, maintenance, troubleshooting, and calibration of electrical and instrumentation systems used in electrolysers test stations, with strong focus on safe execution, equipment reliability and rapid R&D modifications.
Key Responsibilities- Perform installation, maintenance, and troubleshooting of electrical panels, sensors, transmitters, and field instruments.
- Support commissioning and operation of test stations in day or night shifts.
- Carry out wiring, cable termination, loop checking, and signal verification.
- Monitor results from the test equipment if it is in operating condition.
- Assist in calibration and maintenance of instruments.
- Monitor and rectify electrical and instrumentation faults during testing.
- Maintain electrical & instrumentation documentation, checklists, and records.
- Ensure compliance with electrical safety standards and SOPs.
- Follow approved SOPs, JSA/JHA, Permit-to-Work (PTW) and Lockout/Tagout (LOTO) requirements.
- Follow safe practices for hydrogen, oxygen, nitrogen, compressed gases, pressurized water and alkaline electrolyte, where applicable.
- Confirm isolation and safe condition before opening electrical compartments of the test equipment.
- Use required PPE, maintain good housekeeping and immediately report leaks, unsafe conditions, damaged equipment or abnormal operation.
- Knowledge of general electrical devices used in circuit.
- Experience in wiring, termination, loop checking, and calibration.
- Knowledge of sensors, transmitters, RTDs, control valves, and panels.
- Ability to read electrical schematics and P&IDs.
- Basic knowledge of PLC/HMI systems and troubleshooting.
Electrolyser or hydrogen test systems (added advantage, not mandatory); Instrumentation and control systems, PLC/HMI-based systems; Sensors, transmitters, analyzers, control valves, and industrial panels; Industrial testing, commissioning, and maintenance of process plants.